Martin MiniMAC Maestro Manuel d'utilisateur télécharger pdf (Page 8)

8Introduction

Lamp safety

• Do not operate the luminaire with missing or damaged covers, shields,

lenses or ultraviolet screens: an unshielded discharge lamp emits UV

radiation that can cause burns and eye damage.

• Do not stare directly into the light output. Never look at an exposed lamp

while it is lit.

• A hot discharge lamp is under pressure and can explode without

warning. Allow the luminaire to cool for at least 20 minutes and protect

yourself with safety glasses and safety gloves before replacing the lamp

or servicing the luminaire internals.

• If the quartz envelope of a discharge lamp is broken, the lamp releases a

small quantity of mercury and other toxic gases. If a discharge lamp

explodes in a confined area, evacuate the area and ventilate it

thoroughly. Wear non-porous safety gloves when handling a broken

discharge lamp. Treat broken or used discharge lamps and used safety

gloves as hazardous waste and send to a specialist for disposal.

• Replace the lamp if it becomes visually deformed, damaged or in any

way defective

• Replace the lamp at the latest when it reaches the limit of its average life

as specified in this manual or by the lamp manufacturer.

• Install only an approved lamp.

Guarding against burns and fire

• Do not attempt to bypass the thermostatic switch or fuses. Replace

defective fuses with ones of the specified type and rating.

• Keep all combustible materials (for example fabric, wood, paper) at least

1 meter (39 inches) away from the fixture. Keep flammable materials well

away from the fixture.

• Do not illuminate surfaces within 1 meter (39 inches) of the fixture.

• Install the fixture outdoors or in a well ventilated area.

• Do not place filters or other materials over the lens. Use only Martin

accessories to modify beam shape.

• The exterior of the fixture becomes very hot, up to 90° C (194° F) during

normal operation. Do not locate the fixture in areas where accidental

contact is likely.

• Allow the fixture to cool for 20 minutes before servicing

• Do not modify the fixture or install other than genuine Martin parts.

• Do not operate the fixture if the ambient temperature (T

) exceeds 40° C

(104° F).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 83 84

Pas de commentaire

Martin MiniMAC Maestro Manuel d'utilisateur Page 8