Martin MiniMAC Maestro Manuel d'utilisateur télécharger pdf (Page 42)

42 Stand-Alone show playback

1. Disable stand-alone operation. See “Stand-Alone Settings” on page 36,

under the chapter “Programming from a PC using MUM”.

2. Enable lamp-on from the MC-X. See “MC-X lamp off” on page 25 in the

section “Defining fixture settings using MUM”.

Connecting and using the MC-X Controller

1. Connect the MC-X controller to the Exterior 600’s data network. If

multiple Exterior 600s are connected, plug the controller into the first

fixture in the link.

2. To trigger scenes 00-06, press the numbered preset buttons on the MC-

3. To have each fixture run its own routine, press [Auto].

DMX controller override during

stand-alone show playback

If an Exterior 600 is connected to a DMX controller and receives DMX

signals during show playback, the Stand-Alone show will stop running and

the fixture will respond to the DMX controller. DMX signals always have

priority over the running of a Stand-Alone show.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

Pas de commentaire

Martin MiniMAC Maestro Manuel d'utilisateur Page 42