66 Lamp maintenance
Installing the lamp
WARNING! Always disconnect the fixture from AC power and allow it to
cool for 20 minutes before installing the lamp.
1. Isolate the fixture from AC power. If it is
hot, allow it to cool for at least 20 minutes
before proceeding. The lamp is under
high pressure when hot and can explode:
use safety goggles to protect your eyes.
2. Remove the nut from the M10 bolt at the
top of the fixture and remove the bolt.
3. Loosen the bottom bolt slightly, if
necessary, and tilt the rear section
back no more than 45° to avoid
damaging the electrical conduit
beneath the fixture.
4. Remove the four 5mm Allen
screws from the lamp access plate.
Remove the access plate and its
rubber seal.
5. Remove the 2 Phillips screws from
the lamp-socket assembly. Gently
pull out the assembly.
Commentaires sur ces manuels