Martin MiniMAC Maestro Manuel d'utilisateur télécharger pdf (Page 36)

36 Programming from a PC using MUM

Stand-Alone Settings

The fixture needs to be configured to know if and when to activate a stand-

alone program:

Click Stand-alone settings to display the following window.

The following options are available:

Stand-alone

operation

Activates or deactivates stand-alone operation.

Auto program Enables the stand-alone program to start

automatically when the fixture is powered-on. If a

DMX signal is removed from the fixture and this

setting is enabled, the fixture will resume stand-alone

operation.

Master/slave Specifies if the fixture is a single, “master”

(triggering), or “slave” (receiving trigger signals)

fixture.

No more than one fixture may be the master. Any

fixture on the link, however, regardless of its position,

may be the master. All other fixtures must be set as

slave fixtures.

Stand-alone

timer settings

See “Setting a timer trigger” on page 37.

Stand-alone

light sensor

settings

“Setting a light-level trigger” on page 37.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 83 84

Pas de commentaire

Martin MiniMAC Maestro Manuel d'utilisateur Page 36