Martin MiniMAC Maestro Manuel d'utilisateur télécharger pdf (Page 15)

AC power 15

4. Remove the 2 screws from the aluminum circuit-board bracket (A) and

pull the circuit board out.

5. Unplug the power cable’s brown lead from the back of the main fuse

holder (B). The lead is connected with a spade plug and can be pulled

off.

6. Remove the green/yellow lead from the grounding bolt (C) to the left of

the ballast.

7. Disconnect the blue lead from the connection block (D) located in front

of the transformer.

8. Loosen the large outer nut on the power cable gland (E). Cut cable ties

as necessary and pull the power cable out of the fixture.

9. Transfer the outer cable gland nut (E) to the new cable and then insert

the new cable through the cable gland. Pull the cable into the fixture and

cut to 52 cm (20 in.) from the inside of the cable gland.

10. Remove 28 cm (11 in.) of outer insulation. Lead the cable between the

fuse holder and housing (at B).

11. Install a ring terminal on the ground lead (green/yellow), place the

terminal on the grounding bolt to the left of the ballast (C), and replace

the nut.

12. Strip 6 mm (1/4 in.) of insulation from the neutral lead (blue) and screw

the lead into the neutral terminal of the connection block in front of the

transformer (D).

A A

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 83 84

Pas de commentaire

Martin MiniMAC Maestro Manuel d'utilisateur Page 15