Martin CX-2 Manuel d'utilisateur télécharger pdf (Page 19)

CX-2 user manual Troubleshooting 19

ROUBLESHOOTING

Problem Probable cause(s) Remedy

One or more of the fixtures is

completely dead.

No power to fixture. Check that power is switched on

and cables are plugged in.

Primary fuse blown. Replace fuse.

Secondary fuse blown. Replace fuse.

Fixtures reset correctly but all

respond erratically or not at all

to the controller.

The controller is not connected. Connect controller.

XLR pin-out of the controller

does not match pin-out of the

first fixture on the link (i.e.

signal is reversed).

Install a phase-reversing cable

between the controller and the

first fixture on the link.

Fixtures reset correctly but

some respond erratically or not

at all to the controller.

Bad data link connection Inspect connections and cables.

Correct poor connections.

Repair or replace damaged

cables.

Data link not terminated with

120Ω termination plug.

Insert termination plug in output

jack of the last fixture on the

link.

Incorrect addressing of the

fixtures.

Check DIP-switch settings.

One of the fixtures is

transmitting as a master or is

defective.

Bypass one fixture at a time

until normal operation is

regained: unplug both

connectors and connect them

directly together. Have the

defective fixture serviced by a

qualified technician.

An effect fails to reset correctly. The effect requires mechanical

adjustment.

Contact Martin technician for

service.

No light. Lamp missing or blown Disconnect fixture and replace

lamp.

Lamp cuts out intermittently or

burns out too quickly.

Fixture is too hot. Allow fixture to cool.

The transformer setting does not

match local AC voltage.

Check AC setting.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Martin CX-2 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Lumières des projecteurs Martin CX-2