Martin CX-2 Manuel d'utilisateur télécharger pdf (Page 11)

CX-2 user manual Stand-alone operation 11

TAND

ALONE

OPERATION

The CX-2 may be operated without a controller in stand-alone mode. It may be

operated as a single unit or together with other CX-2s in “master/slave”

configuration.

Several options are available to modify stand-alone operation. These options are

selected using the DIP-switch as described below.

Important! The CX-2 transmits a signal when DIP-switch pins 2 and 10 are

set to ON. To avoid damage to the electronics, connect no

more than 1 transmitting device (master or controller) to the

data link.

SINGLE UNIT OPERATION

The fixture defaults to stand-alone mode with music trigger whenever power is

applied and there is no control signal. Options for trigger type, change speed, and

lamp intensity may be selected as described under “Stand-alone settings”.

MASTER / SLAVE OPERATION

Multiple CX-2s can be connected together, without a controller, for synchronized

“master/slave” operation in which the slaves mimic the behavior of the master,

which may be any one of the connected fixtures.

To connect units for master / slave operation

1 Connect the output of one CX-2 to the input of the next CX-2.

2 Connect additional CX-2s output to input. Up to 32 may be connected.

3 Terminate the link on both ends by inserting a

female

termination plug (P/N

91613018) into the data

input

of the first fixture and a

male

termination plug

into the data

output

of the last fixture. The female terminator may not be

required if the first fixture is the master.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Martin CX-2 Manuel d'utilisateur Page 11