Martin MAC 500 Manuel d'utilisateur télécharger pdf (Page 25)

Routine maintenance 25

4. Carefully clean the optical components. Remove smoke and other residues with cotton swabs or

unscented tissues moistened with isopropyl alcohol. A commercial glass cleaner may be used, but

residues must be removed with distilled water. Clean with a slow circular motion from center to edge.

Dry with a clean, soft and lint-free cloth or compressed air. Remove stuck particles with an unscented

tissue or cotton swab moistened with glass cleaner or distilled water. Do not rub the surface: lift the

particles off with a soft repeated press.

5. Remove dust from the head fans and air vents with a soft brush, cotton swab, vacuum, or compressed

air.

6. On each side of the head, remove the 2 screws that hold the side covers. Slide the covers forward to

remove. Clean the air filters or replace them. If they are saturated with smoke fluid, etcetera, soak them

in warm soapy water and blot dry. Position the filters on the side covers and reinstall. See Figure 20.

7. Reassemble the head.

8. Remove the screws from the side cover/grill on the front of the base (front is indicated by an arrow on

the bottom). Remove the top cover from the front of the base. Lift the power supply / ballast module up

and out to expose the base fans for inspection and cleaning.

9. Reinstall the power supply / ballast module and base cover.

Lubrication

The MAC 550 Profile does not require lubrication under normal circumstances. The slides for the zoom and

focus lens cars are lubricated with a long-lasting teflon-based grease that can be reapplied by a Martin

service partner if necessary.

Software installation

Software updates are available from the Martin web site and can be installed via the data link with a Martin

upload device.

The following are required in order to install software.

• The MAC 550 Profile update file, available for download from the User Support Area of the Martin web

site (http://www.martin.com).

• The Martin Software Uploader program, version 5.0 or later, available for download from the User Support

Area of the Martin web site.

• A Martin MP-2 Uploader connected to a Windows 95/98/ME/2000/XP PC, or one of the PC controller

DMX interfaces supported by the Martin Software Uploader software.

To install software, normal method

Please refer to the MP-2 user manual and the Martin Software Uploader online help file.

Figure 20: Air filter replacement

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Pas de commentaire

Martin MAC 500 Manuel d'utilisateur Page 25