Martin MAC 500 Manuel d'utilisateur télécharger pdf (Page 12)

12 MAC 550 Profile

• The shortcuts (PERS>SCUT) setting determines whether the gobo and color wheels take the shortest

path between two positions, crossing the open position if necessary, or always avoid the open position.

Dimmer

The dimmer curve setting (PERS>dICU) provides two options for dimmer behavior. Select dIM1 to

simulate tungsten dimming or

dIM2 for more linear dimming.

Display

The display intensity (PERS>dINT) setting controls display brightness. Select AUTO for automatic

display or manually set the intensity to a level from

10 to 100.

The display on/off setting (

PERS>dISP) determines whether the display remains on (ON), remains on for

2 minutes after the last key press (2 MN), or for 10 minutes after the last key press (10MN).

To flip the display, press [Up] and [Down] simultaneously.

Lamp

There are two settings that modify lamp control: Automatic Lamp On (PERS>ALON) and DMX Lamp Off

(

PERS>DLoF).

When

ALON is OFF, the lamp remains off until a “lamp on” command is received. When ALON is ON, the

lamp strikes automatically after the fixture is powered on. When

ALON is set to DMX, the lamp strikes

automatically when the fixture receives DMX data, and it extinguishes 15 minutes after DMX data is lost.

When

ALON is set to either ON or DMX, the automatic lamp strike timing is staggered to prevent all lamps

from striking at once. The delay is determined by the fixture address.

The DMX Lamp Off (

DLoF) setting allows you to enable (ON) or disable (OFF) the DMX command that

switches off the lamp. The special combination of DMX values listed on page 14 allows you to execute the

lamp-off command even when disabled.

DMX reset

The DMX reset (PERS>dRES) setting controls the behavior of the reset command. When set to ON, the

command is fully enabled. When set to

OFF, the command is disabled to prevent accidental resets. When

set to 5SEC, the command must be sent for five seconds.

Color blackout

The color blackout (PERS>ColB) setting enhances blackout effectiveness. When set to ON, the color

wheels deploy 3 seconds after dimmer blackout. The color filters absorb any tiny amount of light that may

escape past the dimmer.

The color wheels take a fraction of a second longer to open than the dimmer blades, however, so setting

this feature to OFF allows the fixture to snap open more rapidly after a blackout.

Readouts

Time

INFO>TIME provides readouts of fixture hours (HRS), lamp hours (L HR), and lamp strikes (L ST).

Under each item is a resettable (RSET) increment counter and a non-resettable (TOTL) counter for total

accumulated hours/strikes since fabrication. To reset an increment counter, display it and then press [Up]

until it reads 0.

Temperature

INFO>TEMP provides readouts of the head and base temperature in Celsius and Fahrenheit.

Firmware version

INFO>VER displays the version number of the installed firmware. The firmware version is also displayed

briefly at startup.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Martin MAC 500 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs de DJ Martin MAC 500