9 Operation
OPERATION
The 516-II DMX to 0-10 V Converter is ready to operate when
• the DMX mode is selected,
• the voltage setting (115/230 V) is correct,
• a plug has been installed on the power cable and the power cable is plugged in,
• the controller and analog devices are connected and plugged in,
• the control address is set on the DIP-switch.
Martin mode operation
1 Flip the power switch on the front panel of the converter to ON. Apply power
to the controller and the analog devices.
2 Set levels for the analog devices as described in the controller user manual.
DMX dimmer operation
1 Flip the power switch on the front panel of the converter to ON. Apply power
to the controller and the analog devices.
2 Set levels for the analog devices by accessing the converter on the DMX
controller and setting the corresponding channels between 0 and 255. The
relationship between voltage and DMX level is shown below: values are
approximate.
4 5 6 7 8 9 : ; <
58 83 :8 433 458 483 4:8 533 558 583
433
3
9ROWV
'0;
Commentaires sur ces manuels