Martin DMX Switch Pack Manuel d'utilisateur télécharger pdf (Page 5)

5Setup

MARTIN MODE SETUP

The converter automatically switches to Martin mode when used with Martin

protocol controllers. You may wish to swap the polarity of the serial data link

connectors as described below so they have the same pin-out as the controller.

XLR pin-out

The converter’s serial data link sockets are factory set to the DMX pin-out. For

use with Martin protocol controllers, you can either switch the pin-out or use a

phase-reversing cable between the controller and the converter.

1 Disconnect the converter from power. Remove the top cover, which is

secured by 1 screw on each end and 3 screws on the back.

2 Locate the jumpers at PL112 on the small circuit board.

3 Position the jumpers as shown below for the desired pin-out.

4 Replace the top cover before applying power.

AC power

Warning! For protection from electric shock, the converter must be

grounded (earthed). The AC mains supply shall have overload

and ground-fault protection.

CHECK VOLTAGE SETTING

Before use verify that the converter’s power supply is correctly set for the local

AC voltage.

• Locate the 115/230 V selector switch on the back. Select the voltage that most

closely matches your AC supply.

INSTALL A PLUG ON THE MAINS LEAD

The converter’s mains lead must be fitted with a grounding-type cord cap that fits

your power distribution cable or outlet. Consult a qualified electrician if you have

any doubts about proper installation.

DMX pin-outMartin pin-out

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Martin DMX Switch Pack Manuel d'utilisateur Page 5