Martin ATOMIC 3000 Manuel d'utilisateur télécharger pdf (Page 19)

Atomic 3000 user manual Remote controls 19

ATOMIC DETONATOR

The optional Detonator remote control provides the following:

• Slider controls for flash rate and intensity

• Momentary push button control of the blinder effect

• Momentary push button for single flash and flash synchronization

• Run/stop toggle switch

• Chase/sync toggle switch

DATA CONNECTION

Important: Do not terminate the data link when using the Detonator!

The Detonator connects to the Atomic 3000 with a 3-pin XLR data cable.

Additional Atomic 3000s may be connected in series, output to input, for remote

control of up to 20 fixtures. Note, however, that the data link must not be

terminated as described DMX controllers.

If a signal splitter is used to branch the data link, it must be placed after the

master fixture (see below), as the splitter does not transmit power to the remote

control.

MODE SETTING

Important: Connect no more than 1 master to the remote control!

Chase Sync

Run Stop

Intensity

Flash

Rate

Flash rate control

Single flash and

synchronization

Run/stop toggle

Chase/Sync toggle

Intensity control

Blinder effect

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Pas de commentaire

Martin ATOMIC 3000 Manuel d'utilisateur Page 19