Martin ATOMIC 3000 Manuel d'utilisateur télécharger pdf (Page 12)

12 Controller operation Atomic 3000 user manual

DMX CONTROL MODES

The DMX control options are selected on the Mode DIP switch.

1-channel DMX mode allows you to strobe from 0

flashes per second to the maximum flash rate and trigger

the blinder effect from the controller. To select 1-

channel DMX operation, set pin 5 of the Mode DIP

switch to on; set pins 1 to 4 to off.

3-channel DMX mode provides control of flash

intensity, flash duration, and flash rate for more

advanced control than 1-channel mode. To select 3-

channel DMX operation, set pins 1 to 5 of the Mode DIP

switch to off.

4-channel DMX mode provides six special effects in

addition to flash intensity, duration, and rate control. To

select this 4-channel DMX operation, set pins 1, 2, 3,

and 5 to off; set pin 4 to on.

CONTROL ADDRESS

The control address, also known as the start channel, is the first channel used to

receive instructions from the controller. The address may be any channel from 1

to 511 and is set on the Address DIP switch.

The Atomic 3000 uses 1, 3, or 4 channels depending on the control mode. For

independent control, each fixture must be assigned its own address and non-

overlapping control channels. Two or more Atomic 3000s may share the same

address if individual control is not required.

To set the DMX address

1 Select an address for the fixture on your controller. Look up the DIP switch

setting for the address in the table below.

2 Set pins 1 through 9 ON (1) or OFF (0) as listed in the table. Set pin 10 to OFF.

2 3 4 516

1-channel DMX

mode setting

2 3 4 516

3-channel DMX

mode setting

2 3 4 516

4-channel DMX

mode setting

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Martin ATOMIC 3000 Manuel d'utilisateur Page 12