Martin MiniMAC Maestro Manuel d'utilisateur télécharger pdf (Page 31)

Stand-alone operation

Add scene (SCE/Add): Save settings in a new scene at the end of the sequence.

Insert scene (SCE/InS): Save settings in a new scene before the current scene,

which moves up a number. Tip: Think of the Add and Insert commands as Save

commands, to be used as the last step after programming all effects.

Delete scene (

SCE/dEL): Remove the current scene from memory. Scenes

above the deleted scene move down a number.

Next scene (

SCE/nE): Step to the next scene.

Previous scene (SCE/PrE): Step to the previous scene.

Clear scenes (SCE/CLr): Remove all scenes from the fixture memory.

EFFECTS COMMANDS

Lamp on (LOn): Apply power to the lamp. In DMX Stand-Alone Mode, this

command must be programmed in at least one scene if the automatic lamp on

feature is disabled.

Lamp off (

LOF): Turn off the lamp. A hot lamp must cool for several minutes

before it will strike again.

Shutter control (

SHU): Open, close, and flash the shutter at different speeds. (See

Table 2.)

Focus adjustment (

FOC): Set focus position.

Indexed gobo selection (gob/ind): Select a gobo for projection at a fixed

angle.

Rotating gobo selection (

gob/rot): Select a gobo for projection with

continuous rotation.

Gobo index (

rgo/CrS, Fin): Set gobo angle. (Applies only when an

indexed gobo is selected.) Select

CrS first, set the rough angle, and then fine-tune

with

Fin. (See Table 2.)

Gobo rotation (rgo): Set speed and direction of continuous rotation. (Applies

only when a rotating gobo is selected.)

Pan position (

PAn/CrS,Fin): Set pan angle. Select CrS first, set the

rough angle, and then fine-tune if desired with

Fin.

Tilt position (tIL/CrS,Fin): Set tilt angle. Select CrS first, set the rough

angle, and then fine-tune if desired with

Fin.

TIMING COMMANDS

Scene wait time (UUA): Set the scene wait time in seconds.

Scene fade time (FAd): Set the scene fade time in seconds.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Martin MiniMAC Maestro Manuel d'utilisateur Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Caméras de sécurité Martin MiniMAC Maestro