Martin MiniMAC Maestro Manuel d'utilisateur télécharger pdf (Page 27)

Stand-alone operation

number on each fixture can all be triggered to start simultaneously by a master

fixture. This is further explained in the section “About scene timing” on page 29.

FIXTURE SETUP

Important: The IR mode address is different from the DMX mode address

and can only be set after rCS or rCr has been selected.

To setup multiple fixtures for DMX Stand-Alone operation

1 Plug a data cable into the OUT socket of the first fixture and the IN socket of the next

fixture. Repeat as required to connect up to 32 fixtures.

2 Insert a male termination plug (P/N 91613017) into the OUT socket of the last fixture.

If you experience random “flicker” or other unexplained control problems, insert a

female termination plug (P/N 91613018) into the IN socket of the first fixture.

3 Set all fixtures to DMX mode 4. From the control panel, scroll to

Pro in the main

menu, press [enter]. Select

d4. Press [enter] to activate the setting. Address setting

is not required.

4 Using the run options under the control menu set the execution settings of the

respective fixtures to run as slaves, or as the master (only one fixture on the link may

be the master). See “Execution commands” on page 32.

5 (Optional) Set the personality options described on page 19.

6 Study “About scene timing” on page 29, ensuring that you understand it and then use

the menus to program scenes into each fixture. See “Menu commands” on page 30.

To setup one fixture for IR Stand-Alone operation

1 Insert the receiver module into the serial data In socket. Position the sensor arm as

desired but avoid turning it more than necessary.

2Scroll to

Pro in the control panel main menu, press [enter], and scroll to rCS.

Press [enter].

3 Select

Adr from the main menu and press [enter]. Select an address from 0 to 9

and press [enter].

4 Stand 2 meters (6 ft.) away from the fixture, point the remote control at the receiver,

and press the lamp power button. If there is no response, try the ID button. If there is

still no response, reverse the sensor head by rotating the sensor arm 180° and folding

it over.

5 (Optional) Set the gobo blackout, display, and automatic lamp-on personality options

as described on page 19.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 50 51

Pas de commentaire

Martin MiniMAC Maestro Manuel d'utilisateur Page 27