Martin Magnum 850 Manuel d'utilisateur télécharger pdf (Page 18)

18 Basic service

Basic service

Before servicing the Magnum smoke machine, read and observe all the

precautions listed in “Safety information” on page 3. Any service not described in

this section must be carried out by a Martin service technician.

Cleaning

Excessive dust, smoke fluid, and dirt buildup will degrade performance and

cause overheating and damage to the machine that is not covered by the

product warranty. To maintain adequate cooling, dust must be cleaned from the

outer casing and air vents of the machine periodically.

Isolate the machine from power and allow to cool completely before cleaning.

The smoke output nozzle remains hot for up to 10 hours after use.

• Remove dust from the air vents with a soft brush, cotton swab, vacuum,

or compressed air.

• Clean smoke fluid residues from the fog output of the machine using a

damp cloth.

• Clean the outer casing with a damp cloth only.

Fuse replacement

The main fuse for the Magnum 850 smoke machine is located on the electronics

board inside the unit. The fuse for the Magnum 650 is located in a tray on the

mains connector.

DANGER! Disconnect the power supply before removing any covers. Live parts

inside!

850: To replace the fuse, disconnect the power cord from the supply, unscrew

the screws holding the top cover of the unit and remove the cover. The

electronics board is located at the back of the unit near the remote control

sockets. Remove the fuse holder cover and pull out the fuse.

650: To replace the fuse, disconnect the power cord from the mains plug on the

rear panel. Using a screwdriver, pull out the small fuse compartment underneath

the plug. Lift out the fuse.

Remove the spent fuse and replace with one of exactly the same size and rating.

The fuse type is indicated below. Contact Martin Service if the fuse blows

repeatedly.

Magnum 850

120V = 10AT

230V = 5AT

Magnum 650

120V = 10AT

230V = 5AT

1 2 ... 13 14 15 16 17 18 19 20 21

Pas de commentaire

Martin Magnum 850 Manuel d'utilisateur Page 18