Martin Magnum 850 Manuel d'utilisateur télécharger pdf (Page 10)

10 Installation and setting up

Installation and setting up

DANGER! DO NOT operate the Magnum smoke machine until you have read

and observed all the precautions listed under “Safety information” on page 3.

Location

The Magnum smoke machine should be located on the floor or a suitably robust

surface.

The machine can operate in any orientation from 45 degrees upwards to 45

degrees downwards. Steeper tilting may cause fluid leakage.

Do not suspend the machine over areas where people will be underneath.

Ensure that there is at least 100mm clearance all round the machine and at least

600mm in front of the smoke output.

AC power

Before using the machine, ensure that a grounding-type (earthed) power plug

that fits the local power outlets is installed on the power cable.

DANGER! Make sure the power plug is correctly rated:

• For EU (230V) use fit a plug rated 6 amp minimum

• US (120V) models must be fitted with a plug rated 10 amp minimum

When installing the plug, follow the plug manufacturer’s instructions and connect

pins as follows:

yellow and green wire to ground (earth), blue wire to neutral and brown wire to

live.

The table below shows some common pin identification schemes.

wire function marking screw colour

brown live “L” yellow or brass

blue neutral “N” silver

green/yellow earth

green

Before connecting the Magnum smoke machine to power, verify that the AC

supply is adequately dimensioned for the current draw of the machine. The

machine requires:

Magnum 650: 2.66A at 230V (EU) or 6.1A at 120V (US)

Magnum 850: 3.4A at 230V (EU) or 6.6A at 120V (US)

Check that the local AC voltage is appropriate, as indicated on the machine’s

serial number label. If your AC voltage is outside the appropriate range, do not

use the machine. Contact Martin Service for assistance.

Setting up

Fill the fluid container with MARTIN-approved fluid (see page 17).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Pas de commentaire

Martin Magnum 850 Manuel d'utilisateur Page 10