Martin DMX Switch Pack Manuel d'utilisateur télécharger pdf (Page 11)

Service 11

Installing a lamp in the T-Rex

1 Disconnect the fixture from AC power. If replacing a lamp, allow it to cool for 5

minutes before removing the lamp access cover. The lamp cools faster with the

cover in place.

2 Remove both screws from the lamp access cover and lift the cover off.

3 If replacing a lamp, grasp the old lamp by the reflector and pull it out of the holder.

Then pull the socket off the lamp. Do not pull the wires.

4 Push the socket fully onto the pins of the new lamp.

5 Gently push the lamp into the holder until it snaps into place.

6 Replace the lamp access cover and screws.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Martin DMX Switch Pack Manuel d'utilisateur Page 11