Martin RoboColor III Guide de l'utilisateur télécharger pdf (Page 24)

APPENDIX A DIP switch settings for Martin intelligent light units

To achieve proper control of the Units connected to the 2308 Controller you will have to

address these so they match with the controller configuration, or vice versa. You can use

any of the addresses from 1 through 8. If you are not sure about this procedure then refer

to the user’s manual for the particular Unit for detailed information.

The following table shows which DIP-switches that you will have to switch on in order to

address any of the eight controller channels.

DIP-Switch settings

Unit/Channel no. DIP-switch ON

1,2

1,3

2,3

1,2,3

Martin 2308 Controller Version 2.1/3.1 Page 25

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 60 61

Pas de commentaire

Martin RoboColor III Guide de l'utilisateur Page 24