Martin RoboColor III Manuel d'utilisateur télécharger pdf (Page 18)

18 Service and Maintenance RoboColor III

3 Place the new CPU in the IC socket, ensuring that all pins enter the socket

correctly, and that the CPU is correctly oriented. Then press it firmly into the

socket.

XLR PIN-OUT

If the RoboColor III is operated via a DMX controller, you can change the XLR

pin-out to eliminate the need for phase-reversing cables. This can be done inside

the RoboColor III controller by moving two jumpers as shown below.

CPU (IC101).

Heat sink of IC102.

Jumpers for swapping

+ and - signals on

data in and output.

Pin 2 =

Pin 3 =

Pin 2 =

Pin 3 =

Reversed: Non-Reversed

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Martin RoboColor III Manuel d'utilisateur Page 18